1-1/8" (29mm) Engine Cylinder Flex-Hone Ball Hone 180 grit BRM BC11818

Description

tool with a soft cutting action. Whether it's a superior surface finish, deburring a hole, or blending an edge, the Flex-Hone provides a non-directional or crosshatched pattern which is optimal for a variety of applications. Better finishes result in increased product performance and longer product life.
The tool's abrasive selection includes: Silicon Carbide, Aluminum Oxide, Zirconia Alumina, Boron Carbide, Tungsten Carbide, Levigated Alumina, Diamond, CBN and Ceramic. Grit sizes from 20 to 800 are available in most abrasive types.
The Flex-Hone is designed for a variety of automotive, hydraulic, pneumatic and industrial applications in sizes from 4mm (0.157") - 36" (914mm) standard. Special sizes and abrasives are available upon request.
Instructions:
1. The Flex-Hone can be used in a variety of rotating spindles from CNC equipment to a portable hand drill. Recommended RPM range is 500 to 1200 RPM. Do not use air tools or high speed motors.
2. Use a 10-30 weight or Flex-Hone Oil, except when honing hydraulic brake cylinders. When honing hydraulic brake cylinders use the hydraulic brake fluid as a honing lubricant.
3. Have the Flex-Hone Tool rotating upon entry and removal from the cylinder.
4. Use 60-120 strokes per minute depending on
RPM. Final stroking may be accelerated to develop a 45 degree cross-hatch angle.
5. Honing time should be approximately 20-45
seconds per cylinder.
6. Do not use solvents for honing or cleaning..
7°
Clean cylinders after honing with warm or hot water and detergent using a brush, and then oil the cylinder.
Brush Research Manufacturing Co., Inc.
4642 Floral Drive, Los Angeles, CA 90022
(323) 261-2193 Fax (323) 268-6587
www.brushresearch.com
Caution:
Safety goggles or full face shields MUST BE WORN by all OPERATORS and OTHERS IN THE AREA while operating Flex-Hone Tools. Comply with the requirements of ANSI Z87.1 "Occupational Eye