-40%
TIG Foot Pedal Control - On/Off + Current Control 2 Pin + 3 Pin *FAST US SHIP*
$ 512.15
- Description
- Size Guide
Description
PlasmaDyn©
Plasma Cutter Replacement Parts
Experts
in Plasma Cutting Parts, Service & Repair for over 10 Years
Includes:
TIG Foot Pedal - 10K Pot with Adjustable Input on Front
this pedal comes WITHOUT plugs
This Foot Pedal is for TIG & MIG welders using a
2 Pin + 3 Pin Plug
Most MOST Chinese Made machine (using 2 pin + 3 Pin plugs)
Precisely Control your TIG Welder Current for the ultimate in welding
ON/OFF + Current Control - BEST PRICE ANYWHERE!!
Includes:
2k ohm - 10k ohm 2W potentiometer
fits virtually all TIG welders using a voltage controlled current output circuit
~12 foot heavy duty neoprene jacketed cord
comes with NO PLUGS
The wiper wire is the current control wire and can be determined by checking
the middle wire on the potentiometer inside the foot pedal. You must determine
the 'wiper' input of your machine - this is the wire that controls output
Note: - plugs are NOT INCLUDED - we sell several types below:
Miller - 14 Pin Plug available here
Large 7 Pin Plug (5/8") available here
Small 7 Pin Plug (1/2") available here
Small 2 Pin + 3 Pin Plug (1/2") available here
Note: you must understand how to connect this part - we are not able to accept returns for fitment or compatibility.
or - buy this foot pedal with both
plugs pre-connected HERE
YOU MUST VERIFY COMPATIBILITY BEFORE PURCHASE
Fits MOST Chinese TIG/Plasma welders with 2 + 3 Pin Connectors
This Foot Pedal will work - uses standard 10K potentiometer
Please be sure YOUR machine is Foot Pedal Capable
Schematic and Instructions Link
See hook-up schematic and pin-out below
Note: you MAY have to swap the wires inside the foot pedal
to accommodate
your machine -
we can always offer help
You MUST BE SURE This Pedal Fits and Works with your machine
Sorry, there are no returns due to fitment or if your machine wont work with this pedal
Sorry - we cannot tell you if it does or if you need a 10k pot -
but if your machine has a 2 pin + 3 pin connection - it probably will work
Note: you may have to swap wires inside pedal
For Compatibility Questions - please call us at 314-329-8553
A suggested method to hook this pedal up to your voltage sensing TIG welder
Find the on/off connection of your machine (Pedal Red-Black)
Find the 2 pins where you get voltage ~ 20-30V (Pedal - Blue Green)
The remaining wire is the wiper wire (Pedal - Grey)
If the control is backwards - reverse Pedal Blue & Green
NOTE: WIRE COLORS VARY ON EVERY FOOT PEDAL
EXAMPLE diagram ONLY - wire colors will vary on each foot pedal